Important! The software is licenced to the UC motion controller. Please specify who or which company the license should apply. Note that it may take up to 24h before you get your software. These are settings and codes to work with a Raw machine that uses printer ports as well as Drivers as electronics. Cost 168Eur.īoth machines will work just as well, but we have not yet created codes for our UCCNC touchoff plate, but you can only calibrate the height so far, which is enough for most.Īs a customer, you will have access to a raw profile. You need a Motion Controller UC100 about 100Eur. If you do not have a PC and must buy one, you might as well use your own or a modern computer with USB port. If you have an old PC with printer port, you can buy Mach3 and you’re done. UCCNC feels modern and has good support so the choice is yours and you can plan as follows: You can use any program you want, but all functions we have such as calibration and ATC etc are only available for Mach3 at this time. The Raw machines use Mach3 as default and the machine is designed for this program. (read more on the product UC100, or UC300 itself) UC motion controllers are an adapter for translating LPT signals to USB so that the machine can be used on a computer without a printer port.

To use this software, you will need the UC100, UC300 or UC400ETH motion controllers.

UCCNC software that replaces, for example, Mach3 or Mach4 Buy both UC100 and UCCNC at the same time.

Uc100 usb motion controller mach3 cnc